Archive

Published: Građevinar 72 (2020) 9
Paper type: Scientific research paper
Download article (Croatian): PDF
Download article (English): PDF

Analysis of model helical piles subjected to axial compression

Yakup Türedi, Murat Örnek

Abstract

An investigation into axial compression capacity of single helical piles placed in dry sand through laboratory model tests and numerical analyses is presented. The compressive bearing capacities were compared with existing theoretical results given in the literature. Laboratory model tests were performed to determine some design parameters of helical piles such as the plate number, plate diameter, and plate spacing. A good correspondence between experimental, numerical, and theoretical results was established.

Keywords
Helical pile, compression, model test, numerical analyses, sand

HOW TO CITE THIS ARTICLE:

Türedi, Y., Örnek, M.: Analysis of model helical piles subjected to axial compression, GRAĐEVINAR, 72 (2020) 9, pp. 759-769, doi: https://doi.org/10.14256/JCE.2660.2019

OR:

Türedi, Y., Örnek, M. (2020). Analysis of model helical piles subjected to axial compression, GRAĐEVINAR, 72 (9), 759-769, doi: https://doi.org/10.14256/JCE.2660.2019

LICENCE:

Creative Commons License
This paper is licensed under a Creative Commons Attribution 4.0 International License.
Authors:
421 page 1531855978
Yakup Türedi
Iskenderun Technical University, Turkey
Faculty of Engineering and Natural Sciences
Civil Engineering Department
murat1
Murat Örnek
Iskenderun Technical University, Turkey
Faculty of Engineering and Natural Sciences
Civil Engineering Department